Product Overview
Features
- This product is an upgraded version. Compared with the old dual-drive V6, the upgraded version replaces the capacitors and uses multiple small capacitors of 200uf and 100uf to make the electric adjustment body smaller
- Reasonable use of printed circuit board space, thereby increasing the effect of overcurrent and heat dissipation, reducing the cost of post welding, and making the board surface cleaner
- The upgraded version of dual-drive V6.6 newly added a spark-proof switch, which effectively and safely protects the power contacts from being burned and oxidized by electric sparks, protects the electronic components of integrated circuits from breakdown and damage, and prevents electric sparks that may cause explosions
- On the basis of the old version, a new receiver interface is added-it is more convenient to plug in and out when adapting the receiver, eliminating the original PPM cable, making the ESC more concise. Also keep the original PPM cable so that it can be adapted to more styles of receivers
- Make full use of the space to reduce the size of the printed circuit board, the size like the hand center of an adult male, so that it can fit more size products
Specifications
- Item Type: Brushless ESC
- Material: Aviation aluminum alloy
- Model: Dual-drive V6 integrated version
- Dual FSESC6.6 Plus (Pro swtich) based on Dual FSESC6.6
- Upgrade Function:
- Professional Version Switch:
- Press the button to turn on/off the power
- Added Can bus connector for easier 4WD settings
- Change the USB port welding process to SMT welding instead of manual welding
- Change the large capacitors to SMT mounted capacitors and add more MOSFET at the bottom.
- Specification:
- Hardware: V 6.6
- Firmware: Latest firmware version
- Voltage: 8V-60V for dual ESC (3S to 12S LiPo safety)
- Peak voltage must not exceed 60V
- Current: Continuous 100A single, total 200A, instantaneous current 400A / single, total 800A, used for system instantaneous current. The value depends on the installation of the device and the ambient temperature
- 5V 1.5A output for a single external electronic device
- 3.3V 1A output for a single external electronic device
- Mode: DC, BLDC, FOC (sine)
- Supported Sensors: For ABI/HALL/AS5047
- ERPM: 150000
- Size: Approx. 78 x 78 x 20mm / 3.1 x 3.1 x 0.8in (including heat sink)
- Motor Wire: 12AWG
- Power Cord: 8AWG
- Recommended Bullet Connector: 4MM bullet connector
- Reminder: Detected Battery Voltage Tolerance: +/- 0.6V
- Other detailed specifications are the same as Dual FSESC6.6
Package List
1 x Dual FSESC6.6 + Heat Sink
2 x VESC Sensor Cable
1 x LED Button (connected to the ESC)
1 x Micro USB
1 x User Manual
Note
The LED button is inserted into the shipping state of the switch by default. If the LED button is not connected, do not turn on the power.
