Product Overview
Features
- It can be used as high voltage source for high school science experiment, electronic instrument, negative ion generator and little science
- After the input of DC3.6-6V voltage, a dc high voltage of about 20,000V (about 1-2 cm of arc) can be obtained at the output end.
- Module output double arc, a sound can not ignite smoke /paper, a silent can ignite smoke /paper/ candle
- According to the tesla coil principle, the module outputs high voltage pulse current, small volume and high efficiency.
- The peripheral circuit is simple (simply connect the switch, Install the battery), the discharge intensity is violent.
Specifications
- Features:
- It can be used as high voltage source for high school science experiment, electronic instrument, negative ion generator and little science After the input of DC3.6-6V voltage, a dc high voltage of about 20,000V (about 1-2 cm of arc) can be obtained at the output end. Module output double arc, a sound can not ignite smoke /paper, a silent can ignite smoke /paper/ candle According to the tesla coil principle, the module outputs high voltage pulse current, small volume and high efficiency. The peripheral circuit is simple (simply connect the switch, Install the battery), the discharge intensity is violent.
- Specification:
- Input voltage: DC3.6-6v Output voltage: DC400kV--600KV Discharge distance between poles: 5-15mm Output current: 0.5A-1A
- Size: 4.3*4*2.4cm/1.7*1.6*0.9in Weight: Approx.78g/2.8oz
- Wiring method:
- Dual input end: red wire : "+", yellow wire: "-"
- Dual output end: gold wires(no need to distinguish +,-; Fix the output distance between the two wires before charging)
- Package list:
- 1 x Double Arc Pulse Generator
- Note: 1.Avoid high-voltage no-load power supply. (it is necessary to adjust the appropriate distance of the high-voltage cable end before energizing. The distance of the high-voltage cable to pull the arc is directly proportional to the voltage and capacity of the battery used. When measuring arc distance, the test shall be conducted from short to long. 2.Power is strictly forbidden when exceeding the maximum arc distance. As the high voltage energy cannot be released, modules are easily damaged. 3.Due to the high power, the internal heat is not easy to be dissipated, the time of each power supply should be controlled within one minute. 4.About the input power: 2 pcs3.7-v lithium battery can be used in series, such as 18650 battery, idle cell phone battery (to remove the protection board, recommended capacity above 2000mAh) or Nickel-cadmium/Ni-mh battery pack, or 6V lead Acid batteries
